Sunday, June 18, 2017

How To Guide Bathtub Reglazing NYC

By Jason Myers


Have you ever walked into construction store only to find that there were hundreds of reasons why you should not own a tub like the one you have at home? As you are looking through the tub section, you find that there are brand new tubs that put your own tub to shame, with it scratches and grime that will not come off with even the strongest detergent. Let's focus on the following article on resurfacing the Bathtub Reglazing NYC.

It is an absolute priority to get that surface clean of all soap by scrubbing with an abrasive cleaner, for example Ajax, Comet, and a scrubber pad, plus razor blade for those stubborn brown soap deposits. It takes a longer period just doing this step properly to make the tub look original again! Remove all sealing from tub, specially silicone materials. Don't hurry make sure the surface is very clean for efficiency.

The days of china white and bisque are behind us. The introduction of newly improved long lasting urethane products gives homeowners new options to spice up the look of their generic looking white bathtub. Granite finishes come in over 50 different color schemes making it possible to match up to an existing granite counter top or wall surround. It can be applied to sinks, shower pans and counter tops as well. The process is very similar to a standard refinish.

A professional bathtub refinisher generally will start the following process: he or she will prepare the surface of the tub, clean it, repair any damage spots (if necessary), mask off the surrounding areas, apply a color coordinated primer, granite flex, and then several coats of a clear top coat to give it the final touch.

They are somewhat expensive to replace and they both need to be installed as well. If someone accepted to re-work a lavatory for example, then, it will budget a lot additional than if one is to re-work a boudoir, for it will rate more to change the efficacies and mount them. In the typical bedroom, most are equipped with, perhaps, the bed and the cupboard along with a nightstand. Not so for the bathroom.

This material is going to be sprayed on if you're going to get a professional job. You must make sure the surrounding walls, cabinets and fixtures not being done get the protection they need, clear painter's plastic is the best choice, attached with masking tape. Remember the whole process is dangerous and so some attention is needed when handling.

A professional HVLP (High Volume Low Pressure) spray system and professional breathing apparatus is a necessity for these coatings, again these are strong odors and fumes that should be handled by trained and skilled painters only. Solvent wash tub surface, air dry with spray system hose specially the drain area and use a Tack Cloth to finally remove dust. Mix and spray urethane primer, according to manufacturer's recommendations and recommended dry times. Mix and spray Polyurethane topcoats, again to supplier specs. These materials should cure and be ready for use anywhere from 24 to 48 hours under normal temperatures and job conditions.

Bathtub resurfacing is a relatively inexpensive means. Getting more money for the buck with you thinking about such things as reglazing the tub. These are two different procedures that tend to have the same effect - a new looking tub in your bathroom. Everybody wants something looking attractive to the eye and so this will be the best option for whoever intends to do that.




About the Author:



No comments:

Post a Comment